Connecting Power - Advantech DSA-3300 User Manual

5. Insert the Compact Flash card slightly into the CF socket.
6. DO NOT push the CF card too hard when the slide is not matching. It might cause damage
to the CF card and the socket. When it's not easy to slide the CF card into the socket, you
need to flip the CF card over and try again.
7. Use a screw tool to push the CF card inward to make sure a tight connection between CF
card and socket.
Warning: Be careful not to touch and push any component on the PCB board.
Notice: The Compact Flash socket is allocated as Secondary IDE Master (IDE-1).

3.7 Connecting Power

Connect the DSA-3300 to a 12~24V DC power source. The power source can either be from
a power adapter or an in-house power source.
Warning: For the automotive application, the power voltage is very unstable during the
key ignition and might be lower to 12V DC. Please make sure the system is not under
booting or operating. The unstable power source might cause the shot-down to the
system and the data loss.
- 35 -