Simrad CS90 Quick Start Manual page 11

functions to dedicated buttons and switches. This
includes user settings.
Prerequisites
Before you can assign custom user settings to the
operating panel, a selection of settings must be
available from the
User Settings
dialog box is located on the
User Settings
menu.
Context
The
Operating Panel
functionality to the programmable buttons. This
page is located in the
dialog box is located on the
Installation
The four buttons on the "top" of the operating panel
are dedicated for user settings.
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
This dialog box contains a number of pages
selected from the menu on the left side.
3 On the left side of the
select
Operating Panel
4 Under
User Setting Buttons
predefined setting to each button on the
operating panel.
5 At the bottom of the page, select
your settings.
dialog box. The
page is used to assign
dialog box. The
Installation
Setup
menu.
Installation
dialog box opens.
Installation
dialog box,
Installation
.
, assign one
Apply
6 Continue your work in the
box, or select
Defining the middle position of the
transducer
The hull unit provided with the CS90 is designed
to lower the transducer down below the ship's
hull when the CS90 shall be used. When the
Main
CS90 is switched off, the transducer is hoisted
for protection. The CS90 allows you to define a
middle position for the transducer.
Prerequisites
The physical properties of the hull unit installation
are known.
menu.
The correct type of hull unit is selected.
The vessel is berthed or at sea.
Context
Select the middle position carefully. The position
is normally selected to place the transducer just
under the keel, but low enough to prevent echoes
from the trunk. Once the position is selected, make
sure that the system protection functionality does
not inhibit transmission.
.
Procedure
1 Make sure that you have sufficient water
depth below the keel before you lower the
transducer.
2 Open the
3 On the top bar, select
control settings.
4 Select [+] and [–] to adjust the middle position.
to save
5 Open the
442717 / B / 2019-11-15
Installation
to close it.
OK
menu.
Operation
Hull Unit
menu.
Setup
dialog
to access the