John Bunn JB0112-110 User Manual page 8

SETUP
Info: Before initial operation, clean the nebulizer
cup assembly following the instructions given in
MAINTENANCE/Cleaning the Nebulizer Cup.
WARNING: Ensure that the nebulizer compressor is
unplugged during setup.
1. Before each use, inspect the compressor and nebulizer
cup assembly for damage or wear; replace as needed.
2. Place the compressor on a table or other flat stable
surface (not on the floor), in an area that is clean and
dust-free. Be sure you can easily reach the controls
when seated.
3. Open the nebulizer medication cup: Twist the cap
counter-clockwise until it stops, then lift cap off.
4. Pour the prescribed medication into the nebulizer
medication cup. Do not fill with more than 5 ml per
treatment.
5. Install cap on cup. Turn clockwise to
tighten.
6. If using the mouthpiece for
treatment, proceed to step 7. If using
an optional mask, install the bottom
part of the mask directly onto the top
of the nebulizer medication cup cap
as shown at right. Proceed to step 9.
7. Insert mouthpiece into large end of
T adapter.
JB0112-110-INS-LAB-RevC14
cap
cup
install cap
on cup
mask
cap
install mask
on cap
T adapter
mouthpiece
assemble
mouthpiece
and T adapter
8