U-tec Ultraloq U-Bolt Pro Z-Wave Installation And User Manual page 19

4.4 Delete Admin and User
Please reset the lock to Factory Default Mode to delete Admin
and all Users.
How to reset the lock in Standalone Mode?
Please use a Reset Needle to push the Reset Button (at the
bottom of Interior Assembly) for around 3 seconds until you
hear one long beep and two short beeps.
FAQ
1. How to exclude my lock from a Z-Wave hub?
In the hub interface, find the place to remove the lock or follow
the hub instructions to put the hub into exclusion mode.
Open U-tec App，go to Lock Settings, select Z-Wave Control
，tap Remove my lock from Z-Wave hub, then follow the App
instructions to complete the process.
2. How to reset my Z-Wave lock?
Please note all data will be erased if you reset U-Bolt Pro Z-Wave
to factory default. Use this procedure only when your Z-Wave
hub is missing or otherwise inoperable.
Please note that removing your lock from a Z-Wave network does
not reset your lock. You still need to do the following operations if
a reset is to be done.
If you are using U-tec App as Owner, please click "Delete and
Reset" to remove the lock from your U-tec Account, then use a
Reset Needle to push the Reset Button (at the bottom of Interior
Assembly) for around 3 seconds until you hear one long beep and
two short beeps.
If U-Bolt Pro Z-Wave is working as Standalone Mode, please use a
Reset Needle to push the Reset Button (at the bottom of Interior
Assembly) for around 3 seconds until you hear one long beep and
two short beeps.
3. Can I still use U-tec App when my lock is
connected to a Z-Wave hub?
Yes, Ultraloq Z-Wave lock can be operated from both the Z-Wave
hub interface and U-tec App.
4. What if I lost the paired smartphone?
Please go to www.u-tec.com/myutec.html or login U-tec App
via another smartphone to change your U-tec Account password.
- 18 -