U-tec Ultraloq U-Bolt Pro Z-Wave Installation And User Manual page 13

Step2
Open the U-tec App and go to Settings, select Z-Wave Control.
The App should state that "Your Ultraloq Smart Lock has not
been added to a Z-Wave hub yet".
If your lock has been added to a hub already, please follow the
instructions in the FAQ to exclude your lock from the hub first.
Step3
Tap Add to Z-Wave hub,then follow the App instructions to
start the inclusion process. If your Z-Wave hub is Security 2
enabled and requires the Z-Wave QR code or pin code to add the
lock automatically, please find it on the back of the battery cover
of your smart lock.
When U-tec App states that the connection is successful, please
return to your hub interface to complete the setup.
This lock can be operated in any Z-Wave network with other
Z-Wave certified devices from other manufacturers. All
non-battery operated nodes within the network will act as
repeaters regardless of vendor to increase reliability of the
network.
Configuration parameters and association group information can
be found at u-tec.com/Support.
DON'T WANT TO USE THE APP?
Please go to page 17 for programming guide for Standalone Mode.
3. Using Your Lock
3.1 Unlock From Outside
• User Code
Enter 4-8 digit code and press Ultraloq Button to unlock .
- 12 -