Pc Board Assembly - Elenco Electronics TWT-1K Assembly And Instruction Manual

PC BOARD ASSEMBLY

Solder the following parts to the PC board.
Figure A
Mount the resistor flat against
the PC board as shown. Solder
and cut off the excess leads.
Solder Side
R6 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R3 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R7 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R2 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
1 - Blue
1
2 - Orange
8
3 - Black
4 - Red
5 - Green
6 - Yellow
7 - Brown
8 - Gray
PC Board
1. Insert the cable with
RJ-45 plug into the
hole in the PC board
as shown, noting the
direction of the plug.
Plug
2. Insert the eight colored
wires into the corresponding
holes in the PC board as
shown.
Figure B
3. Tug the cable down to the
position shown.
-6-
R8 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R4 - 560W 5% ½W Resistor
(green-blue-brown-gold)
(see Figure A)
R9 - 120W 5% ½W Resistor
(brown-red-brown-gold)
(see Figure A)
R1 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R5 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
8 Wire Cable with RJ-45 Plug
(see Figure B)
4 Wire Cable with RJ-11 Plug
(see Figure C)
4. Turn the PC board
over. Solder the wires
and cut off the excess
leads.