Table of Contents
Advertisement
FINAL ASSEMBLY
Install the push button switch to the front
panel in the hole marked "TEST". Fasten
switch in place with the 1/4" nut. Tighten the
nut with pliers (be careful not to scratch the
panel).
Strip the insulation off both ends of the blue
wire to expose 1/4" of bare wire. Solder one
end to the hole on the copper side of the PC
board, as shown in Figure I. Solder the other
end of the wire to a lug on the push button
switch.
Solder the red wire from the battery snap to
the other lug on the push button switch, as
shown in Figure I.
Insert the black wire from the battery snap
into the pad on the PC board from the copper
side. Solder the wire in place, as shown in
Figure I.
Strip 1/4" insulation off both ends of the red wire. Insert one end into pad "D" on the copper side of
the PC board and solder the wire into place. Tie a knot 2 1/2" from soldered end of wire. Pull the
free end through the hole of the front panel marked "DIODE", see Figure J.
Strip 1/4" insulation off both ends of the black
wire and insert one end into pad "E" on the
copper side of the PC board and solder the
wire into place. Tie a knot 2 1/2" from the
soldered end of the wire. Pull the free end
through the hole of the front panel marked
"E", see Figure J.
Strip 1/4" insulation off both ends of the yellow
wire and insert one end into pad "B" on the
copper side of the PC board and soldered end
of the wire. Pull the free end through the hole
of the front panel marked "B", see Figure J.
Strip 1/4" insulation off both ends of the green
wire and insert one end into pad "C" on the
copper side of the PC board and solder wire
into place. Tie a knot 2 1/2" from soldered
end of wire. Pull the free end through the hole
of the front panel marked "C", see Figure J.
Blue
Battery Snap
Figure I
E
C
Red
"Diode"
-5-
Switch
Red
Figure J
D
B
Knot
Yellow
Black
Green
"B"
"E"
"C"
Black
Advertisement
Table of Contents
