Setting Room Temperature - EdenPURE A5893 Owner's Manual

OPERATING INSTRUCTIONS
1. Start and select working mode
Or
Or

2. Setting room temperature

Caution! Only in Auto heat-up mode can setting temperature be performed.
Or
Or
Turn the heater on by pressing the Power button on the
control panel or by pressing the Power button on the supplied
remote control.
Once power is off, heating element will stop working at first.
The fan will continue to run for approximately three minutes
to emit residual heat inside of the unit.
Select a heat setting.
Press the Mode button to alternate between the two heat
settings.
Under Auto heat-up mode, when the value difference
between set temp and room temp exceeds 5°F or so, the unit
will run at full 1500W, otherwise run at 750W; Under High
heat-up mode, the unit runs at a stable 1500W, when room
temp exceeds 86°F, heat-up stops.
Adjust the thermostat by pressing the arrows on the control
Or
panel or remote control.
Set temperature indication varies from 59°F to 86°F. The
bottom lighting corresponds to the set temperature of 59°F.
The topmost light corresponds to the set temperature of
86°F, totalling 10 lights. Once you have chosen the desired
temperature, the heater will remain on until the room
temperature increases to the temperature on the digital
display. The heater will cycle on and off to maintain the
desired room temperature.
7