Page 1
IMPORTANT SAVE THESE INSTRUCTIONS To ensure you get the best results, please read this manual first and keep it for future reference. For additional information, please contact your place of purchase or call 1-800-225-6595. ® Thank you for choosing EdenPURE...
RISK OF ELECTRICAL SHOCK. DO NOT OPEN. NO USER-SERVICEABLE PARTS INSIDE. ® 1. Read ALL instructions before using the EdenPURE Classic Infrared Heater. 2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself. 3. This heater may get hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces.
Qualified personnel should perform all servicing only. 22. Connect to properly grounded outlets only. ® 23. Some EdenPURE units contain a button battery for the remote. If swallowed, it could cause severe injury or death in just two hours. Seek medical attention immediately.
If this occurs, try inserting the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for damage. IN THE BOX · EDENPURE ® CLASSIC HEATER · REMOTE CONTROL ·...
PRODUCT DIAGRAM Cabinet Remote Control Air Intake Cord Clamp Air Outlet Front Panel Heat Sensor Control Panel Power Switch Wheel Control Panel 1. Indicating light of highest temp: Light’s on when set at the maximum temp. 2. Indicating light of lowest temp: Light’s on when set at the minimum temp. 3.
9. Power switch button: For power-on or off. 10. Power indicator light: Indicates that the heater is receiving power from outlet. Will flash when powered “ON”. Remote Control Mode button: Used for mode selection ON/OFF button: Used for power-on or power-off Temp up button: to make set temperature rise Temp down button: to make set temperature decline PREPARATION...
OPERATING INSTRUCTIONS 1. Start and select working mode Turn the heater on by pressing the Power button on the control panel or by pressing the Power button on the supplied remote control. Once power is off, heating element will stop working at first. The fan will continue to run for approximately three minutes to emit residual heat inside of the unit.
3. Setting electro lock Function of electro lock can avoid misoperation from children. Locking can be set in both power-on and power-off modes. Press Temp Up and Temp Down buttons once for 3 seconds. Locking is fulfilled when you hear one beep. When locked, control panel and remote control failed to function.