Mini Gadgets SC-600RF Operation Manual

Wireless CamCatch
Ope ra on Manual
2.Battery Install
1) Releave the Batt. Compartment cover on the back and put into the Batt.
pack. (please notice the side of the
3.Battery Charge
1) Use the attached power adaptor to charge/power the unit.
( Dont use any other power supply or source from any computer)
4.Charge Indication
1)The red LED goes on under charging while off completing the charge
，
5.Low Power Alert
1) A low-Batt. icon will keep flash on the main screen
，
SC-600RF
+/ -
)
1.Name and Parts
6.Antenna Installation
1) Screw on the antenna according to the number indication
Screw on the Labeled 1 Ant. into the Socket 1
Screw on the Labeled 2 Ant. into the Socket 2
Screw on the Labeled 3 Ant. into the Socket 3
7.Power Switch
1) Push and hold the power button for 3 seconds to open/close the power.
Once power on the unit will start to scan automatically.
Note: Be sure installing all antennas before power on
8.Frequency Scan
1) The picture will be shown on the monitor for a certain dwell time
which＇ve been setup with in previous, once any signal been detetected
pull up or down the setup key to hold the frequency, otherwise will
continue to browse in next.
1.Set-up Key
2.Low Band Antenna Mount
(900 MHz ~ 2324 M Hz)
3.High Band Antenna Mount
(2325 M Hz ~ 3000MHz / 5000 M Hz ~ 6000MHz)
4. 20MHz~ 6GHz Antenna Mount
5.Power Button
6.AV Input Output Port /
7.Charge LED
8.Power Input
9.LCD Setup Screen
10.LCD Video Monitor
11.Battery Tray