Bosch 1375-02H Operating/Safety Instructions Manual page 10

BM 2610004695.qxp_1375 5/13/16 11:07 AM Page 10
WHEEL GUARD INSTALLATION
grinding or cutting wheels. Always keep wheel
guard be tween you and your work while
grinding or cutting.
To attach wheel guard DISCONNECT tool
from power source.
Position guard on spindle neck so that the
notches on guard line up with the keys on the
spindle neck (Fig. 2).
The position of the guard can be adjusted to
accommodate the operation being performed.
Rotate guard in either direction to desired
position, and tighten screw with the hex wrench
provided to secure guard in place.
TO REMOVE GUARD: Loosen screw with the
hex wrench provided, rotate guard until the
LOCK NUT AND BACKING FLANGE
Your tool is equipped with a threaded spindle
for mounting ac ces sories. Always use the
supplied lock nut (and backing flange) that
has same thread size as spindle.
VIBRATION CONTROL SIDE HANDLE
(Optional Accessory)
The side handle is used to control and balance
the tool. The handle must be thread ed into the
front housing on either side of the tool,
depending on per sonal preference and
comfort. Use the side handle for safe control
and ease of operation (Fig. 1).
Assembly
Wheel guard must be
attached when using disc
notches on guard line up with the keys on the
spindle neck, and lift guard off the spindle neck
(Fig. 2).
FIG. 2
KEYS
SCREW
NOTCHES
OPTIONAL HAND GUARD
(Optional Accessory)
The hand guard is to be used with backing
pads, sanding discs and wire brushes to keep
fingers and hand away from work surface,
sharp edges, burrs and debris. When using the
optional hand guard accessory insert side
handle through hole in guard and then thread
into housing (Fig. 1).
Ensure that hand guard is positioned between
hand and backing pad, sanding disc or wire
brush.
-10-