Advertisement
8
model no. 040-1191-2
LOADING BICYCLES ON THE BIKE CARRIER
10
Separate the upper cradle plates (5) from the lower
cradle plates (6) by rotating the hand knobs (4)
counterclockwise until completely removed.
Place the bicycles
in alternating directions on the
11
lower cradle plate (6). Replace the upper cradle
plate (5). Tightly secure the plates using the hand
knobs (4).
Note: Load the heaviest bicycle closest to the
vehicle. If loading three bicycles or less, leave the
outermost rack spaces empty.
Secure the wheel and frame of the bicycle to the
12
bike carrier using straps (7) (not included) to prevent
movement while in transit.
4
5
6
A
4
5
6
7
TILTING THE BIKE CARRIER
To access the rear trunk or hatch of the
vehicle:
13
Remove all bicycles from the bike carrier.
14
Remove the pin clip (F) from the base of the rack
mast (A).
15
With one hand, hold the centre of the rack
mast (A) firmly in place. Use the other hand to
pull the quick-release pin (E) from the base of
the rack mast then lower the rack mast away
from the vehicle.
16
After accessing the vehicle trunk, return the
rack mast to its upright position, insert the
quick-release pin, and secure using the pin clip.
A
F
A
A
E
9
Advertisement
