Mounting And Installation; Connecting Conditions - S+S Regeltechnik AERASGARD FSFTM-CO2-Modbus Operating Instructions, Mounting & Installation

G

Mounting and Installation

CONNECTING CONDITIONS

The voltage outputs are short-circuit proof against earth. The device is destroyed if voltage supply is applied to the voltage output.
SAFET Y REGUL ATIONS
These devices shall only be used for their intended purpose. Respective safety regulations issued by the VDE, the states, their control
authorities, the TÜV and the local energy supply company must be observed. The buyer has to ensure adherence to the building and safety regulations
and has to avoid all dangers of any kind. We do not assume any warranty for faults or damages arising or resulting from improper use of our equipment
or from non-observance of operating instructions. These instruments must be installed by authorised specialists only!
Preferably shielded cables should be used in order to prevent damages ⁄ errors. It is imperative to avoid laying parallel with current-carrying
lines. EMC directives must be adhered to.
POTENTIOMETER
To compensate for different installation heights, two stub axles are provided for the potentiometer, depending on the switch programme.
This is to ensure that the minimum and maximum stops of the potentiometer function properly.
15