Emerson EWR20V5 Service Manual page 31

Reference Notes
CAUTION 1: Locking Tabs (L-1) and (L-2) are fragile.
Be careful not to break them.
1-1. Release five Locking Tabs (L-1).
1-2. Release three Locking Tabs (L-2)
1-3. Disconnect Connector (CN1609), and remove
the Front Assembly.
2. When reassembling, solder wire jumpers as shown
in Fig. D8.
3. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on Main CBA as shown in
Fig. D8. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D8.
(S-1)
[1] Top Cover
(S-2)
[3] Front
Bracket
(L-1)
(L-2)
(S-1)
(S-1)
Fig. D1
[4] Radiation Sheet
(S-2)
(S-3)
Shield
Plate
(L-1)
CN1609
[2] Front
Assembly
(L-1)
Fig. D2
[5] Jack Bracket
(S-5A)
[7] DVD
Mechanism
&
DVD Main
CBA
Assembly
1-6-2
(S-4)
[6] Jack CBA
Jack Earth Plate
Fig. D3
(S-5B)
CN2204
CN201
Fig. D4
E9601DC