Bush Hog 2215R1 Operator's Manual page 95

Tongue
During shipping tongue may be tilted back toward unit.
Roll tongue down into working position. Pin jack stand to
tongue.
LEVEL RODS
Pin the leveling rods assemblies to the tongue using
pin, flatwasher and cotter pins shipped with assembly.
The slotted casting end should be attached to the
tongue (Position for greasing). It may be necessary to
raise the tongue slightly for the attachment of the
leveling rod. Connect the opposite end to the center
axle weldment using the pin and cotter pins shipped in
the leveling rod assembly. Attach hose holder rod to
tongue using 5/8" x 2" bolt, nut, flat washer and
lockwasher.
2215/12215 07/20
© 2020 Alamo Group Inc.
ASSEMBLY
Hose Holder Rod
Tongue
Assembly
Flatwasher
Leveling Rod
Non Slotted
Casting
Center Axle
Assembly Section 3-3
Jackstand
Cotter
Pin
Slotted
Casting
End
Flatwasher
Pin
Cotter Pin