Bush Hog 2215R1 Operator's Manual page 114

OPERATION
LEVELING WING SECTIONS WITH CENTER
Wings should be adjusted before use if they are not level with center deck section. Lower cutter until skids on
center section are approximately 1-2 inches off ground. Remove wing transport lock pin(s) and place in pin
storage hole. (Ops-1874) Lower wing(s) to ground allowing weight to rest on wheel(s). If wing(s) are not level
(parallel) to center section, loosen jam nut and turn turnbuckle body to adjust. (Ops-1875) Adjust shorter to
raise the wing outside edge and longer to lower the wing outside edge. It may be necessary to use wing lift
cylinder to relieve pressure from the linkage retaining pin. Tighten jam nut.
2215/12215 07/20 Operation Section 4-12
© 2020 Alamo Group Inc.