Advertisement
Model:PN-8830
5.1 Topping-Off Tires with
NITROGEN
1. Set the final target pressure.
2. Connect the tire fill hose(s) to the tire valve stem(s).
3. Turn the Fill Control Valve handle to the "FILL" position.
4. Press the
"FILL/PURGE"
button momentarily (for less than 1 second). The unit
will inflate or deflate the tire(s) to the target pressure.
5. When the top-off cycle is completed, the unit will "beep" and the target pressure
will flash on the LCD screen.
6. Wait! As the flow rate of individual tire valves can vary, allow 15 seconds for the
pressure to equalize in the tires before turning the unit off or disconnecting the hoses.
(When topping off a single tire there is no need to wait for pressure equalization).
7. Turn the Fill Control Valve handle to the "STOP" position.
8. Immediately disconnect the tire fill hoses.
Immediately disconnecting the tire fill hoses from the tire valve stems after turning the
Fill Control Valve handle to "STOP" eliminates potential leakage from the tires due to
a loose chuck, connection, etc.
5.2 For use as a Standard Digital Tire Inflator (Single Tire Application)
The inflator can be used as an automatic inflator for rapid tire calibration. For such use, set
OPS and N2P to zero, set target pressure and turn the Fill Control Valve to "FILL."
For this operation, the Fill Control Valve must remain in the "FILL" position and an "Open"
type chuck must be installed on the tire fill hose being used.
6
Advertisement
