Advertisement
Model:PN-8830
3.0 Preparation for Use
1. Plug unit power cord into power source.
2. Connect a compressed air supply line to the inlet located on the Pre-Filter.
3. Turn the red handle of the Fill Control Valve (Fill/Stop Valve) to the "STOP"
position.
4. Turn the unit on by depressing the Power Switch. The Unit will immediately begin
to produce nitrogen. The nitrogen pressure gauge located on the Unit above the
Pre-Filter assembly will indicate the nitrogen pressure in the system.
5. The equipment is now ready to use.
WARNING
To avoid the risk of personal injury, especially to the eyes, face and skin, DO NOT
direct the air stream at any person(s).
CAUTION
To avoid equipment damage, never exceed the maximum inlet pressure.
NOTE: The filter bowls on the Pre-Filter assembly will accumulate water and oil
when the generator is in operation but drain automatically whenever the generator unit
is powered down or the filter housings are depressurized. It is recommended that the
generator unit be powered down when not in use to ensure filter bowls remain drained
and conserve power/unit life.
It is important that the filter elements are replaced on a regular basis (at least
every 6 months) to prevent contaminates from entering the Unit.
4
Advertisement
