Page 3
Please read this user manual first! Dear Customer, Thank you for prefering an product. We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use.
Important instructions for safety and environment This section contains safety instructions that will help protect from risk of personal injury or property damage. Failure to follow these instructions shall void any warranty. 1.1 General safety • This product can be used by children at and above 8 years old and by persons whose physical, sensory or mental capabilities were not fully developed or who lack experience and knowledge provided that they are supervised or trained on the safe usage of the product and the risks it brings out.
Important instructions for safety and environment Always have the installation and repairing procedures carried out by the Authorized Service Agent. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorized persons. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similary qualified persons in order to avoid a hazard.
Important instructions for safety and environment Do not forget to close the lid when leaving the room where the product is located. Store all detergents and additives in a safe place away from the reach of the children by closing the cover of the detergent container or sealing the detergent package.
Installation Refer to the nearest Authorised Service Agent for 3.2 Connecting water supply installation of the product. To make the product The water supply pressure required to run ready for use, review the information in the user the product is between 1 to 10 bars (0.1 manual and make sure that the electricity, tap –...
Installation 3.3 Connecting to the drain The end of the drain hose must be directly connected to the wastewater drain or to the washbasin. WARNING: Your house will be flooded if the hose comes out of its housing during water discharge. Moreover, there is risk of scalding due to high washing temperatures! To prevent such situations and to ensure smooth water intake and...
Installation 3.3.2 Connecting to the drain with pump 3.4 Adjusting the feet The hose should be attached to a height of at The two front feet of washing machine can least 80 cm, and 100 cm at most. adjust the positive, when the washing machine In case the hose is elevated after laying it on is not level, you can up the front of washing the floor level or close to the ground (less than...
Installation 3.5 Electrical connection 3.6 Connection of inlet hose connector and tap Connect the product to a grounded outlet protected by a 6 A fuse. Our company shall not 1. Tighten all hose nuts by hand. Never use a tool be liable for any damages that will arise when the when tightening the nuts.
Installation 3.7 Connecting to the water supply 3.8 Using detergent /softener and bleach nector Important: The water supply pressure required to run the When using detergent, softener, starch, fabric dye, machine must be 1-10 bar (0,1 – 1 MPa). bleachor limescale remover read the anufacturer’s Connect the special hoses supplied with the instructionson the package carefully and follow machine to the water intake valves on the...
Preparation 4.1 Sorting the laundry • Sort laundry according to type of fabric, colour, and degree of soiling and allowable water temperature. • Always obey the instructions given on the garment tags. LAUNDRY WASH SYMBOLS Machine Wash Symbols WASH Maximum Water Temperatures Symbol(s)
Preparation 4.2 Preparing laundry for washing 4.3 Things to be done for energy saving • Laundry items with metal attachments such as, underwired bras, belt buckles or metal buttons Following information will help you use the will damage the machine. Remove the metal product in an ecological and energy-efficient pieces or wash the clothes by putting them in a manner.
Preparation 4.4 Correct load capacity 4.6 Using detergent and softener The maximum load capacity depends on the type Detergent, softener and other cleaning agents of laundry, the degree of soiling and the washing • Add detergent and softener before starting the programme desired.
Preparation Using softeners Using bleaches Pour the softener into the softener compartment Add the bleaching agent to the dedicated of the detergent drawer. If your machine is without detergent drawer or with simple detergent drawer agent and detergent by (detergent drawer that does not include softener department) softener can be put at the dedicated agent compartment on the balance ring.
Operating the product 5.2 Preparing the machine ime, ime, Error Figures in this manual are schematic and Displays the remaining may not match the product exactly. wash time. Displays the reserved delay start time. Power Button Displays the error state if a problem occurs in the Press this button once to washing machine so that...
Page 21
Operating the product This is a device to protect With every press of this children from being button, the function accidentally hurt while changes. playing with the washer. - Press the “Water level” button and ‘’Function’’ button at the same time for 3 sec. Press this button to speed - If Child Lock function is activated, ‘’CL’’...
Operating the product High water and 3 min air turbo options are set Depending on the type of fabric, use the following automatically in this wash course. main programmes. Figures in this manual are schematic and may not match the product exactly. This programme selects the best water level and wash course automatically depending on Wool...
Operating the product 5.4 Auxiliary function selection Figures in this manual are schematic and may not match the product exactly. • Wash • Soaking Select this function if you like to wash your laundry by soaking. Soaking is recommended for heavily soiled laundry items.
Page 24
Operating the product 5.5 Programme and consumption table Functions Air Turbo Duration Program Load(kg) Water Level (min) S/W/R/S W/R/S Spin R/S W/R Wash 15min 30min Auto — — Small Medium Small Wool Extra High Wool High Wool Medium Wool Blanket Extra High Blanket High...
Maintenance and cleaning Service life of the product extends and frequently 6.2 Cleaning the body faced problems decrease if cleaned at regular and control panel intervals. Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as necessary, 6.1 Cleaning the detergent drawer and dry with a soft cloth.
Maintenance and cleaning b. Loosen pump filter (anticlockwise) until water 6.4 Draining remaining water starts to flow. Fill the flowing water into the and cleaning the pump filter container you have placed in front of the filter. The filter system in your machine prevents solid Always keep a piece of cloth handy to absorb items such as buttons, coins and fabric fibers any spilled water.
Page 27
Troubleshooting Problem Check & Solution - Is the electric voltage normal? The power is cut off. - Is the washer plugged in? Plug in the electric cord. - Is the drain hose down? Put the drain hose down. Water does not drain. - Is the drain hose folded? Unfold the drain hose.
Page 28
Troubleshooting Error Error Control Message - Is the water tap shut off? - Is the water supply cut off ? - Is the water supply hose punctured ? - Is the tap or water supply hose frozen ? Water intake over time - Is the water pressure low or is the filter of the inlet valve clogged with impurities? - Is the Hot hose connected to cold?
Need help?
Do you have a question about the HTL65 and is the answer not in the manual?
Questions and answers