Parameter Description; Group-Basic Operating Parameters - HNC HV10 Series User Manual

VI. Parameter description
00 groups-basic operating parameters
Function macro definition (temporarily reserved)
00.00
0～10
0：General model
1：Single pump constant pressure water supply mode
2：Reserved
3：Reserved
4：Engraving machine mode
5～10：Reserved
Note: Initialize the parameters first, and then set the macro function.
Motor control mode
00.01
0～2
0: Normal V/F control
When it is necessary to use a single inverter to drive more than one motor, the control method used when the motor parameter self-learning cannot be performed
correctly or the controlled motor parameters cannot be obtained through other ways. This control method is the most commonly used motor control method. This
control method can be used in any occasion that does not require high motor control performance.
1: Advanced V/F control
This control mode introduces the idea of magnetic flux closed-loop control, which can greatly improve the torque response of motor control in the full frequency
range, and enhance the torque output capability of the motor at low frequency. At the same time, it is not too sensitive to motor parameters like the field-oriented vector
control.This control mode is especially suitable for some occasions that have certain requirements for starting torque (such as wire drawing machines, ball mills, etc.).
2: Vector control (sensitivity of motor parameters)
A true vector control method. In addition to the high torque output performance of the magnetic flux control method, this control method also has the effect of
flexible torque output. It can be described as both rigid and flexible, but this control method is more sensitive to motor parameters. Use it after enabling the dynamic
self-learning of motor parameters, otherwise the effect will be poor.
Run command channel selection
00.02
0～2
This function code selects the physical channel where the inverter accepts operation commands such as running and stopping.
0: The operation panel runs the command channel
Operation control is implemented by the,
1: Terminal operation command channel
Operation control is implemented by multi-function terminals defined as FWD, REV, JOG forward rotation, JOG reverse rotation and other functions.
2： Communication operation command channel
Operation control is implemented by the upper controller through communication.
Main frequency source A selection
00.03
0～7
0: Panel potentiometer setting
The operating frequency is adjusted by operating the potentiometer on the keyboard, and the range of the potentiometer's adjustment frequency is fixed from 0 to the
maximum output frequency [00.04].
1: Digital setting 1, panel
RUN
M-FUNC
, and other keys on the operation panel.
S T O P / R E S E T
31
0
-
0
0