Parameters Instructions - HNC HV10 Series User Manual

V. Parameters instructions
○- Parameters that can be modified in any state
× -Parameters that cannot be modified in the running state
◆-Actual detection parameters, which cannot be modified
◇-Manufacturer parameters, which are only modified by the manufacturer, and users are forbidden to modify them.
00 groups-basic operating parameters
Function Name
code
Function macro
definition
00.00
(temporarily
reserved)
Motor control
00.01
mode
Run command
00.02
channel selection
Frequency given
00.03
selection
Max output
00.04
frequency
Upper limit
00.05
frequency
Lower limit
00.06
frequency
Lower limit
00.07 frequency arrival
processing
Digital setting of
00.08 operating
frequency
Content
0: General model
1: Single pump constant pressure water supply mode
2: Reserved
3: Reserved
4: Engraving machine mode
5: Reserved
6: Reserved
7: Reserved
8: Reserved
9: Reserved
10：Reserved
0: VF control
1: Advanced V/F control
2::Vector control
0: Keypad
1: Terminals
2: Communication
0: Keypad potentiometer
1: Digital given 1, adjust with ▲ and ▼ keys on the operation panel
2: Digital setting 2, adjust with terminal UP/DOWN
3: AI analog setting (0 ～ 10V/0 ～ 20mA)
4: Combination setting
5: Reserved
6: Communication
7：Reserved
Note: When combination given time is selected, the combination given
mode is selected in 01.15.
The maximum output frequency is the highest frequency allowed by the
inverter, and it is the benchmark for setting the acceleration and
deceleration time.
Operating frequency cannot exceed this frequency
Operating frequency cannot be lower than this frequency
0: Zero speed operation
1: Running at the lower limit frequency
2: Stop
This set value is the initial value of frequency digital given
16
Setting range Factory
setting
0～10 0
0～2 0
0～2 0
0～7 0
MAX ｛50.0, 【00.05】 ｝ ～
50.0Hz
999.9Hz
MAX{0.1， 【00.06】 }～
50.0Hz
【00.04】
0.0 ～ upper limit
0.0Hz
frequency
0～2 0
0.0 ～ upper limit
10.0Hz
frequency
Change
×
×
○
○
×
×
×
×
○