Adjusting The Half Cutting Depth; Switching The Printing Pressure; Connecting Ac Adapter - Max LM-550A2 Series Supplementary Manual

BEFORE USE

4-8 ADJUSTING THE HALF CUTTING DEPTH

Half cutting depth can be adjusted with the "Half cutting depth adjustment lever", when half
cutting depth is not adequate.
Note:
When printing on tubes, the lever has to be
positioned on the "TUBE."
When printing on tape or ID plate, the lever
has to be positioned on the "TAPE" choice.
4-9 SW ITCHING THE PRINTING PRESSURE
Printing pressure can be adjusted with the "Printing pressure switching lever."
Note: You don't need to change the strength unless the printed result is too dark.
(Changing from the standard pressure to the low pressure)
1. Check that the release lever is at the
middle position. (The lever is standing)
2. While pressing the lock button, then slide
the printing pressure switching lever to
the right.
3. Now, the strength of the printing pressure
is low.
(Changing from the low pressure to the standard pressure)
1. Ch eck that the release lever is at the
middle position. (The lever is standing).
2. P ress the lock button.
Note: Don't change the head pressure when
the head release lever is positioned as
the figure ("Open" position or "Close"
position).

4-10 CONNECTING AC ADAPTER

1. Insert the AC adapter jack firmly into the connection part on
the right side of the main unit.
2. Insert the power plug of the AC adapter into the outlet/power
point .
.
18
Deep
Shallow
(1) (2)
Low po sition
"Open"
AC adapter
connection
The release lever is
standing.
"Close"