GE PGMS5PJ Manual page 68

REPLACING THE FREEZER DRAWERS
Two people may be required to complete
this procedure.
BOTTOM DRAWER
REPLACE THE BASE GRILLE
1
(if removed earlier)
CAUTION:
overtighten the screws since this may crack
the grille.
Align the base grille and replace the 2 Phillips-
head screws on either side of the base grille.
ATTACH AND SECURE THE DRAWER
2
FRONT TO THE SLIDES
Pull out the rail assemblies to the full length on
A
each side of the cabinet.
Installation Instructions
Be careful not to
(cont.)
ATTACH AND SECURE THE DRAWER
2
FRONT TO THE SLIDES (CONT.)
B There is a tab on each drawer rail and a slot
on each rail assembly on the refrigerator. Align
the drawer rails with the rail assemblies, tilt
the drawer toward the refrigerator, and seat
the tabs into the slots of the rail assembly.
Lower the drawer into position.
Slot Tab
Replace the screws to secure the drawer.
C
Rail
assembly
REPLACE THE FREEZER BASKET
3
Place the rear of the basket onto the metal
A
slide brackets. There will be 2 pins on each
underside of the back that will align for
securing the basket.
Seat the front basket onto the metal slide
B
brackets and over the swing locks.
Turn the swing locks from vertical to horizontal
C
position to lock the basket in place.
Turn the divider slightly to one side so the tabs
D
on the front fit into the vent slots on the basket.
Position the divider so the back locating tabs snap
into place in the back vent slots.
Screw