Installing The Refrigerator; Refrigerator Location - GE PGMS5PJ Manual

INSTALLING THE REFRIGERATOR

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature will
go below 60°F (16°C) because it will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where the temperature will
go above 100°F (37°C) because it will not perform properly.
• Install it on a floor strong enough to support it fully loaded.
CLEARANCES
Allow the following clearances for ease of installation, proper
air circulation and plumbing and electrical connections.
Standard Depth
Models
Sides 1/8ʺ (3 mm)
Top 1ʺ (25 mm)
Back 1ʺ (25 mm)
REMOVE TOP CAP
•IMPORTANT NOTE: This refrigerator is 34-1/2ʺ deep.
Doors and passageways leading to the installation
location must be at least 36ʺ wide in order to leave
the doors and handles attached to the refrigerator
while transporting it into the installation location. If
passageways are less than 36ʺ, the refrigerator doors
and handles can easily be scratched and damaged.
The top cap and doors can be removed to allow the
refrigerator to be safely moved indoors. Start with
Step A.
•If it is not necessary to remove doors, skip Step A.
Leave tape and all packaging on doors until the
refrigerator is in the final location.
•SKID REMOVAL: Tilt refrigerator to each side to
remove skid.
•NOTE: Use a padded hand truck to move this
refrigerator. Place the refrigerator on the hand truck
with a side against the truck. We strongly recommend
that TWO PEOPLE move and complete this installation.
Locate and remove the two Phillips head screws on
A
the top of the refrigerator. Remove the two screws on
each side at the rear of the top cap. Lift off and
remove top cap.
Remove the fresh-food door. Refer to Steps 1 through
B
3 of "Reversing the Door Swing" section.
Remove the bottom freezer drawer. Refer to
C
"Removing Freezer Drawers" section.
Move refrigerator to the installation location.
D
Installation Instructions
Counter Depth
Models
1/8ʺ (3 mm)
1ʺ (25 mm)
1/2ʺ (13 mm)
(on some models)
REMOVE TOP CAP (cont.)
REINSTALL DOORS, DRAWERS AND TOP CAP
Carefully lower the door onto the center hinge. Reinstall
E
top hinge. NOTE: Ensure the door is properly aligned to
the case top to avoid readjustment of the door during
top cap reinstallation.
F Place cap over the top of the refrigerator. Reinstall the
original screws in the top and back of the cap.
G Reinstall the bottom freezer drawer. Refer to "Replacing
the Freezer Drawers" section.
CONNECTING THE REFRIGERATOR
1
TO THE HOUSE WATER LINE
(icemaker and dispenser models)
A cold water supply is required for automatic icemaker
operation. If there is not a cold water supply, you
will need to provide one. See Installing the Water
Line section.
NOTES:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
• If your refrigerator does not have a water filter, we
recommend installing one if your water supply has
sand or particles that could clog the screen of the
refrigerator's water valve. Install it in the water line
near the refrigerator. If using GE SmartConnect
Refrigerator Tubing Kit, you will need an additional
tube (WX08X10002) to connect the filter. Do not cut
plastic tube to install filter.
60
(on some models)
A
Top
Hinge B
™