Related Manuals for Elby Designs CGS738
Summary of Contents for Elby Designs CGS738
- Page 1 CGS738 Mangler CGS738 Mangler Construction Guide Revision 1.0 May 1, 2020 ELBY Designs - Laurie Biddulph 9 Follan Close, Kariong, NSW 2250, Australia elby-designs@bigpond.com http://www.elby-designs.com 1 of 4...
- Page 2 CGS738 Mangler Construction of the CGS738 requires the assembly of 1 board:- Column 1 - CGS738 PCB Model) Constructors should refer to the PCB Overlay for any specific comments regarding the board assemblies, the Bill of Materials for the current value of all components and General Construction Notes for general PCB assembly guidelines.
- Page 3 0V Connect the oscilloscope to the DOWN output and disconnect the TRIANGLE from IN 1. You should see a waveform similar to that shown at left ELBY Designs - Laurie Biddulph 9 Follan Close, Kariong, NSW 2250, Australia elby-designs@bigpond.com http://www.elby-designs.com...
- Page 4 There will probably be a DC offset as you can see here. Adjust the DOWN Trim (P104) until the bottom of the waveform hits ELBY Designs - Laurie Biddulph 9 Follan Close, Kariong, NSW 2250, Australia elby-designs@bigpond.com http://www.elby-designs.com...
Need help?
Do you have a question about the CGS738 and is the answer not in the manual?
Questions and answers