NJD Electronics NJ179 Manual page 5

slave. If there is more than one slave connect a DMX lead from
DMXout on the fist slave to DMXin on the second etc.
DO NOT select slave mode if it is the only luminaire that is
operating.
The DMX START ADDRESS is the DMX address of the first DMX
control channel. The 2nd DMX channel is at the DMX start address
+ 1, the 3rd DMX channel is at the DMX start address +2, etc.
The NJ179 may be controlled from DMX in 3 different modes:
In 3-channel mode the three channels select the colour as follows:
first channel - sets the brightness of the red LEDs.
second channel - sets the brightness of the green LEDs.
third channel - sets the brightness of the blue LEDs.
To select 3-channel mode, press SETUP repeatedly until the display
shows
3-ch.
4-channel mode operates similarly to 3-channel mode but with the
addition of a master dimmer:
The first channel is the master dimmer.
The second channel sets the brightness of the red LEDs.
The third channel sets the brightness of the green LEDs.
The fourth channel sets the brightness of the blue LEDs.
To select 4-channel mode, press SETUP repeatedly until the display
shows
4-ch.
To select 8-channel mode, press SETUP repeatedly until the display
shows
8-ch.
In 8-channel mode , the channels operate as follows:
When the 6th channel is at zero:
The first channel is the master dimmer.
The second channel sets the brightness of the red LEDs.
The third channel sets the brightness of the green LEDs.
The fourth channel sets the brightness of the blue LEDs.
The fifth channel sets the strobe speed.
(0—9 fully on, 10—255 strobing at increasing speed
DMX mode.
Page 5