Summary of Contents for NJD Electronics NJ179
- Page 1 NJ179 LED PAR SPOT 150 10mm LEDs in 3 colours Low power consumption Stand-alone or DMX operation Page 1...
-
Page 2: Before Use
The wires are colour-coded as follows: • Brown = Live (phase) • Blue = Neutral • Green/Yellow = Earth • The NJ179 must be earthed for safe and reliable operation PRODUCT SAFETY This luminaire is for professional use only. It is the owner's •... -
Page 3: General Safety Requirements
For indoor use only. • Do not use in bathrooms, or in wet or damp locations. • Do not place the mains lead beneath a carpet or rug. • Do not allow the cable to hang over the edge of a table. •... -
Page 4: Auto−Run Mode
SLAu in the display. In slave mode, the NJ179 will copy the colours and movements of any other unit to which it connected by a DMX cable. Connect a DMX lead from DMXout of the Master luminaire to DMXin on the... - Page 5 The 2nd DMX channel is at the DMX start address + 1, the 3rd DMX channel is at the DMX start address +2, etc. The NJ179 may be controlled from DMX in 3 different modes: In 3-channel mode the three channels select the colour as follows: first channel - sets the brightness of the red LEDs.
- Page 6 The fifth channel sets the strobe speed. The 7th channel can be used to extend the addressing range by allowing up to 66 NJ179 luminaires to be individually controlled from the same eight DMX addresses. This mode is switched off when the 7th channel is below 9.
-
Page 7: Pat Testing
etc. until 200—209 ID20 ID21 ID22 ID23 etc. until ID64 ID65 ID66 To set the DMX START ADDRESS press SETUP repeatedly until appears in the first character of the display. Then use the UP and DOWN buttons to select the address required. The DMX START ADDRESS is the DMX address of the first DMX control channel. -
Page 8: Technical Specification
TECHNICAL SPECIFICATION Dimensions: 250×260×70 mm Weight: 1·26 kg Power supply: 230 V ˜ Power consumption: 20 W Operating current: 0.09 A Light source: 150 × 10 mm LED Colours: Beam Angle: 30° Mains input: IEC socket DMX Connections: 3-pin XLR Data+ pin 3 Data−...