Auto−Run Mode; Sound Mode; Slave Mode - NJD Electronics NJ179 Manual

= red
1--r
= yellow
2-r9
= green
3--9
= cyan
4-9b
= blue
5--b
= magenta
6-rb
= white
7r9b
To fine-tune the colour press SETUP again until
green) or (for blue) is displayed in the first digit of the display. Then
b
use the UP and DOWN buttons to set the brightness of each colour.
Example from
LEDs will make the colour more orange, and reducing the brightness
of the red LEDs will make the colour more green.
In AUTO-RUN mode, the NJ179 goes through all the built-in
programs in turn. To select AUTO−RUN Press the MODE button
repeatedly until
In AUTO-RUN mode the LED chase speed, flash frequency and fade
speed can be set as above.
To select SOUND mode, press MODE repeatedly until
the first two characters of the display. In SOUND mode, only the
sensitivity can be set.
Press SETUP to change the sensitivity.
will be shown in the first two characters of the display, and the
SU
sensitivity will be shown in the last two characters of the display.
Press UP or DOWN to adjust the sensitivity.
To select SLAVE mode, press MODE repeatedly until
in the display.
In slave mode, the NJ179 will copy the colours and movements of
any other unit to which it connected by a DMX cable. Connect a
DMX lead from DMXout of the Master luminaire to DMXin on the
(yellow), reducing the brigtness of the green
2-r9
AUTO−RUN mode
is shown on the display.
AUTO

SOUND mode

SLAVE mode

Page 4
(for red)
r 9
is shown in
SU
is shown
SLAu
(for