Table of Contents
Advertisement
22
www.electrolux.com
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them up
out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install the
glass panels and the door. Do the above
steps in the opposite sequence. Install the
smaller panel first, then the larger.
10.6 Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
11. TROUBLESHOOTING
11.1 What to do if...
Problem
The oven does not heat up. The oven is deactivated.
The oven does not heat up. The clock is not set.
The oven does not heat up. The necessary settings are
The oven does not heat up. The fuse is released.
CAUTION!
Rough handling of the glass,
especially around the edges
of the front panel, can cause
the glass to break.
WARNING!
Refer to Safety chapters.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
The back lamp
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
4. Install the glass cover.
Possible cause
not set.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp. The
lamp and the lamp glass
cover can be hot.
or deactivate the circuit breaker.
The lamp glass cover is at the
back of the cavity.
counterclockwise to remove it.
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
Advertisement
Table of Contents
