Table of Contents
Advertisement
Faults and what to do about them.
en
Information on the display panel
Display
YES
NO
NO flashes
F:16
F:17
F:18
F:21
F:23
E
N flashes
Faults and what to do about them.
Faults
Water is leaking out.
No water supply.
Detergent not dispensed.
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
drained.
Water not visible in the
drum.
24
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
■
door immediately, if necessary. Select Start/Reload to continue the pro-
gramme.
Wait until YES lights up.
■
Close the door properly; laundry may become trapped.
Turn the water tap on fully,
■
supply hose kinked or trapped,
■
water pressure too low. Clean the screen.
■
Detergent solution pump blocked. Clean detergent solution pump.
■
The drain hose/waste pipe is blocked. Clean the drain hose on the siphon.
■
Motor fault. Call the after-sales service.
Water in the base tub, appliance leaking. Call the after-sales service.
Childproof lock activated; deactivate it.
Too much foam detected, a rinse cycle has been switched on.
Cause/remedial action
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
■
Start/Reload not selected?
■
Tap not turned on?
■
Filter blocked? Clean the screen. ~ Page 22
■
Supply hose kinked or trapped?
■
Safety function active. Programme stopped? ~ Page 19
■
$ (without final spin) selected?
■
Can be opened by emergency release only? ~ Page 23
■
Start/Reload or Finished in time selected?
■
Washing machine door closed?
■
E Childproof lock activated? Deactivate. ~ Page 18
■
$ (without final spin) selected?
■
Clean detergent solution pump. ~ Page 21
■
Clean the waste pipe and/or drainage hose.
■
Not a fault – water below the visible area.
Advertisement
Table of Contents
