Related Manuals for Bosch WAE20464IL Series
Summary of Contents for Bosch WAE20464IL Series
- Page 1 Washing machine WAE20464IL ... en Instruction Manual and Installation Instructions...
- Page 2 Your new washing machine Display rules : Warning! You have chosen a Bosch washing machine. This combination of symbol and signal word indicates a possibly dangerous Please take a few minutes to read and situation. Not heeding the warning can become familiar with the advantages of cause death or injuries.
-
Page 3: Table Of Contents
Contents e n I n s t r u c t i o n M a n u a l a n d I n s t a l l a t i o n I n s t r u c t i o n s Z Water plus*. -
Page 4: Intended Use
Intended use After-sales service ..28 Intended use Consumption rates ..29 For private domestic use only. ■ I n t e n d e d u s e The washing machine is suitable for Energy and water consumption, ■... -
Page 5: Safety Instructions
Safety instructions Reaching into the drum while Safety instructions ■ it is still rotating may cause hand injuries. Electrical safety Do not reach into the drum S a f e t y i n s t r u c t i o n s while it is rotating. -
Page 6: Environmental Protection
Environmental protection Cut through the mains cable Do not let children touch the ■ and remove it, along with the hot washing machine door. plug. Destroy the lock on the ■ washing machine door. Environmental Warning Risk of suffocation! protection Children may become wrapped Packaging/used appliance in packaging/film or packing... -
Page 7: Main Points In Brief
Main points in brief Main points in brief M a i n p o i n t s i n b r i e f Connect the mains Turn on the water Sort the laundry. Open the washing plug. tap (for models machine door. -
Page 8: Getting To Know The Appliance
Getting to know the appliance Getting to know the appliance Washing machine G e t t i n g t o k n o w t h e a p p l i a n c e ( Detergent drawer ~ Page 18 8 Washing machine door with door handle 0 Controls/display elements 9S Open the washing machine door... -
Page 9: Control Panel
Getting to know the appliance Control panel (G Speed*, F Eco*, p Reduced 8 Temperature, 5 Finished in/Ready in, Spin Speed for changing the programme Ironing, O Rinse Plus/ Z Water Plus (Aqua Plus)* additional programme settings default settings (* depending on the model) $ = Rinse Stop Overview of all additional programme settings Overview of all programme default settings... -
Page 10: Laundry
Laundry – Ž : Do not wash the laundry in Laundry the machine. S orting laundry Prepare the laundry L a u n d r y Sort your laundry according to the care Caution! instructions and manufacturer's Damage to the appliance/fabrics information on the care labels, Foreign objects (e.g. -
Page 11: Detergent
Detergent Saving energy and detergent Detergent For light and normal soiling, you can C orrect selection of detergent save energy (lower washing D e t e r g e n t temperature) and detergent. The care label is crucial for selecting the correct detergent, temperature and Saving Soiling/note... -
Page 12: Overview Of Programmes
Overview of programmes Overview of programmes Programmes on the programme selector O v e r v i e w o f p r o g r a m m e s Programme/type of laundry/information Settings Name of the programme Max. load; Brief explanation of the programme and for which fabrics it is suita- * Reduced load for the G Speed ble. - Page 13 Overview of programmes Programme/type of laundry/information Settings W / l Wool Max. 2 kg Hand- or machine-washable fabrics that are made of wool or contain a - 40 °C wool; $ ... 800 rpm Particularly gentle wash programme to prevent shrinkage of laundry, with longer programme breaks (fabrics rest in the detergent solu- tion) Notes...
-
Page 14: Starching
Overview of programmes Programme/type of laundry/information Settings ] Sportswear Max. 2 kg Fabrics made of microfibre for sport and leisure a - 40 °C Notes $ ... 800 rpm Laundry must not be treated with fabric softener. ■ F, G, p, O / Z Before washing, clean the detergent drawer thoroughly (all com- ■... -
Page 15: Programme Default Settings
Programme default settings The maximum speed that can be set Programme default depends on the model and programme that have been selected. settings Overview of programmes ~ Page 12 The temperature, spin speed and P r o g r a m m e d e f a u l t s e t t i n g s programme duration ("Finished in"... -
Page 16: Additional Programme Settings16
Additional programme settings O Rinse plus* Adding laundry while the preselected time continues running: Extra rinse. For areas with very soft Press Start/Reload. water or to further improve the rinsing The symbols YES and ¼ light up in result. the display panel. The washing machine door can be opened and laundry can be added. -
Page 17: Operating The Appliance
Operating the appliance Change the programme Operating the default settings appliance You can use the default settings or Preparing the washing change them. O p e r a t i n g t h e a p p l i a n c e machine To do this, repeatedly press the corresponding button until the required... -
Page 18: Placing Laundry Into The Drum
Operating the appliance Placing laundry into the drum Measure and add detergent and care products Warning Risk of death! Caution! Items of laundry pretreated with Damage to the appliance cleaning agents that contain solvents, Cleaning agents and agents for e.g. stain remover/cleaning solvent, pretreating laundry (e.g. -
Page 19: Start The Programme
Operating the appliance Dilute viscous fabric softener and Do not use the measuring aid for Note: Note: fabric conditioner with water; this gel detergents and washing powder, or prevents blockages. for programmes with prewash or when the "Finished in" time is selected. Pour the detergent and care products into the appropriate compartments: For models without a measuring aid,... -
Page 20: Adding Laundry
Operating the appliance The childproof lock can remain Changing the programme Note: activated until you wish to start the next programme, even after switching off the If you have started the wrong machine. programme by mistake, you can You must then deactivate the childproof change the programme as follows: lock before starting the programme and Select the other programme. -
Page 21: Removing Laundry/Switching Off The Appliance
Sensors Removing laundry/switching Sensors off the appliance A utomatic load sensing Open the washing machine door S e n s o r s and remove the laundry. The automatic load sensing function Turn the programme selector to Off. adapts the water consumption ideally to Appliance is switched off. -
Page 22: Setting The Signal
Setting the signal Setting the signal S e t t i n g t h e s i g n a l 1. Activate the setting mode for the signal volume Set to Ú One step, the display Select and hold One step, release panel lights up 2. -
Page 23: Machine Housing/Control Panel
Cleaning and maintenance Machine housing/control panel Wipe the housing and the control ■ panel with a soft, damp cloth. Do not use any abrasive cloths, ■ scourers or cleaning agents (stainless steel cleaners). Clean the detergent dispenser tray Remove the detergent residue and insert with water and a brush, ■... -
Page 24: The Drain Hose At The Siphon Is Blocked
Cleaning and maintenance For models with a drain hose: Take the drain hose out of the retainer. Remove the sealing cap; allow the detergent solution to flow out into a suitable container. Replace the sealing cap and place the drain hose in the retainer. Place the service flap back on, lock it into place, and close it. -
Page 25: Filter In The Water Supply Blocked
Faults and what to do about them. Filter in the water supply Faults and what to do blocked about them. Warning Emergency release Risk of electric shock! F a u l t s a n d w h a t t o d o a b o u t t h e m . Do not immerse the Aqua-Stop safety E.g. -
Page 26: Information On The Display Panel
Faults and what to do about them. Information on the display panel Display Cause/remedial action The washing machine door is unlocked. It is possible to add laundry. Temperature too high. Wait until the temperature drops. ■ Water level too high. Not possible to add laundry. Close the washing machine ■... -
Page 27: Faults And What To Do About Them
Faults and what to do about them. Faults and what to do about them. Faults Cause/remedial action Water is leaking out. Attach/replace the drainage hose correctly. ■ Tighten the screw connection of the supply hose. ■ No water supply. Start/Reload not selected? ■... -
Page 28: After-Sales Service
After-sales service Faults Cause/remedial action Intense noise, vibrations Are the appliance feet fixed? Secure the appliance feet. ~ Page 35 ■ and "wandering" during Transport locks removed? Remove the transport locks. ~ Page 32 ■ spinning. Noises during spin and Clean the detergent solution pump ~ Page 23 drain cycles. -
Page 29: Consumption Rates
Consumption rates Consumption rates Energy and water consumption, programme duration and C o n s u m p t i o n r a t e s residual moisture for the main washing programmes Programme Load Energy consumption*** Water*** Programme dura- tion*** Cottons 30 °C** 7 kg... -
Page 30: Technical Data
Technical data Technical data Positioning and connecting Dimensions: T e c h n i c a l d a t a 850 x 600 x 590 mm Included with the appliance P o s i t i o n i n g a n d c o n n e c t i n g (height x width x depth) Weight: 68 - 75 kg (depending on the model) -
Page 31: Safety Instructions
Positioning and connecting Notes Caution! Check the machine for transport Water damage ■ damage. Never use a damaged The connection points for the water machine. If you have a complaint, supply hose and water drain hose are please contact the retailer from under high water pressure. -
Page 32: Installing The Appliance In A Kitchenette
Positioning and connecting Installing the appliance in a kitchenette Warning Install the appliance (underneath the worktop or fitted in a cabinet) before connecting it to the power supply. Take the hoses out of the holders. Notes Recess width of 60 cm required. ■... -
Page 33: Hose And Cable Lengths
Positioning and connecting Hose and cable lengths Water inlet Left-hand connection Warning ■ Risk of death! There is a risk of electric shock if you touch live components. Do not immerse the Aqua-Stop safety valve in water (it contains an electric valve). -
Page 34: Water Outlet
Positioning and connecting Model: Standard Height difference between the ■ ■ installation surface and the drain: Min. 60 cm, max. 100 cm You can lay the water drain hose as follows: Drainage into a washbasin ■ Warning Risk of scalding! Model: Aqua-Secure ■... -
Page 35: Levelling
Positioning and connecting Electrical connection Warning Risk of death! There is a risk of electric shock if you touch live components. Never touch or hold the mains plug ■ with wet hands. Only pull out the mains cable by the Levelling ■... -
Page 36: Before Washing For The First Time
Positioning and connecting Before washing for the first Transportation time E.g. when moving house The washing machine was thoroughly Preparatory work: tested before leaving the factory. In Turn off the water tap. order to remove any water which may Reduce the water pressure in the be left over from the test, run the first supply hose. - Page 40 0344 892 8979 (Calls charged at local or mobile rate.) 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.) You can find the contact information for all countries in the attached after-sales service directory. Robert Bosch, Hausgeräte GmbH Carl-Wery-Straße 34 81739 München DEUTSCHLAND...