Gasmate EH240 Manual
  1. Manuals
  2. Brands
  3. Gasmate Manuals
  4. Electric Heater
  5. EH240
  6. Manual

Gasmate EH240 Manual

Bar table electric heater
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
BAR TABLE ELECTRIC HEATER
Model No. EH240
Maximum output 1600W infrared
heating elements
70cm Diameter tempered glass table top
Bar table height - 110cm
High efficiency carbon fibre element
Stainless steel base
Safety tip-over switch
Suitable for outdoor entertaining areas
IP24 Approved
Important: Retain these instructions for future use
Gasmate® is a registered trademark of:
Sitro Group Australia Pty Ltd www.gasmate.com.au
Aber Living, N.Z www.gasmate.co.nz
04258 12/20

Advertisement

Table of Contents
loading

Related Manuals for Gasmate EH240

Summary of Contents for Gasmate EH240

  • Page 1 High efficiency carbon fibre element Stainless steel base Safety tip-over switch Suitable for outdoor entertaining areas IP24 Approved Important: Retain these instructions for future use Gasmate® is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au Aber Living, N.Z www.gasmate.co.nz 04258 12/20...

  • Page 2: Important Safeguards

    IMPORTANT SAFEGUARDS To reduce the risk of personal injury or damage • Avoid operating the Product on long pile carpet to property, follow basic safety precautions when or uneven surfaces. Use only on flat, level and using this product, including the following: stable surfaces.

  • Page 3: Before First Use

    BEFORE FIRST USE • The power supply must be supplied through a residual device (RCD) having a tripping current UNPACK THE PRODUCT not exceeding 30mA. • Carefully unpack the Product making sure • Only connect this heater to a socket-outlet you keep all the packing material until all the having an earthing contact.
  • Page 4 OPERATING INSTRUCTIONS TO TURN HEATER ON/OFF Note: This heater requires a 1.5m clearance on all sides. 1. Always operate a Free Standing Heater on a dry, stable and level floor surface, well away from curtains, drapes and soft furnishings. DO NOT operate this Product immediately below an electrical Socket Outlet.

  • Page 5: For Your Safety

    Care & Cleaning 1. After each use, make sure the Product is turned OFF and DISCONNECTED from the FOR YOUR SAFETY Power Supply. Let the Product cool after use before moving, cleaning or storage. 2. Clean the exterior of the Product by wiping •...

  • Page 6: Electrical Data

    Australian requirements for connection to the mains supply. If in doubt always consult a Screw M6*10 qualified electrician. Base Bracket TECHNICAL SPECIFICATION Base Cover Model EH240 S/S Tube Voltage 220-240V AC 50Hz Spring Washer Ø6.2 Input Wattage 800 ~ 1600W Foot Bracket I.P Rating...
  • Page 7 ASSEMBLY BASE ASSEMBLY FIG. A FIG. A 1. Turn the Base upside down and attach both Wheels (5) and then screw in both Feet (1) and adjust them to the same level as the Wheels. 2. Turn the base the correct way up and place the Base Cover (9) on.
  • Page 8 ASSEMBLY FIG. D GLASS TOP ASSEMBLY FIG. D Stand the Heater up the right way on its base. If needed adjust the Feet (1) to stop the Heater rocking. 10. Place Glass Top (17) on top of the Heater Body. Make sure the screw holes on Table Mount (18) line up with the holes on top of the heater.

Table of Contents