Table of Contents
Advertisement
Quick Links
CLASSIC RADIANT HEATER
EH600X SERIES
FEATURES
• Metal radiant heater no glowing element
• Adjustable wall and ceiling bracket
• Black anodised aluminium
• 1.5m long power cord
• Designed for outdoor use
• Ideal for use under verandahs, garages or alfresco areas
• EH631X - requires 15A power point to be installed by qualified electrician
Gasmate
®
is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au
Aber – Hamilton, N.Z.
www.gasmate.co.nz
Important: Retain these instructions for future use.
03381 11/15
Advertisement
Table of Contents
Related Manuals for Gasmate EH611X
Summary of Contents for Gasmate EH611X
- Page 1 • Ideal for use under verandahs, garages or alfresco areas • EH631X - requires 15A power point to be installed by qualified electrician Gasmate ® is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au Aber – Hamilton, N.Z. www.gasmate.co.nz Important: Retain these instructions for future use.
- Page 2 Never yank or pull on the power cord to disconnect For any queries or assistance call it from the mains supply socket. Never carry your heater by its’ power cord. Keep the power cord away from heat, oil, solvents and sharp edges. Check the power cord regularly for any damage and if the power cord becomes damaged have it Customer Service...
-
Page 3: Specific Safety Instructions
Specific Safety Instructions WARNINGS Do not use the heater in areas where • NEVER use with the power cord coiled, there is a risk of explosion or fire from bundled up or tied up. Always extend fully flammable gases. Ensure that the heating area before use. -
Page 4: Electrical Data
If in doubt always consult a qualified electrician. Note: EH631X (3200W) requires installation of a 15AMP socket by a qualified electrician before use. Technical Specification Slimline Heater EH611X EH621X EH631X Voltage 220-240V AC ~ 50Hz... - Page 5 Mounting Heating General Mounting Suggestions If unsure please discuss with your local hardware store. • Ensure the fixing screws are at least suitable for 10Kg each. • If fitting to a stud wall or ceiling ensure all fixing screws are into timber. Plasterboard IS NOT suitable by itself.
- Page 6 Ceiling Mount with Chain Only use this mounting option if your ceiling is too high. 1. Attach the bracket (C) as noted below. 2. Cut chain (D), not supplied, to desired length. 3. Using nut and bolt attach chain to bracket (C) and bracket (B).
- Page 7 Heater positioning eave/ceiling 1. Position heater at least 200mm from the eave lining or ceiling. 2. Position heater at least 1.8m above the floor. 3. Never position in front, above or below a power point. 4. If heater is facing another vertical surface, example –...
- Page 8 Do not return to place of purchase. Keep your purchase receipt, this will be required to make any claims under the 12 month warranty. Gasmate ® is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au Aber Ltd - Hamilton, N.Z www.gasmate.co.nz...
Need help?
Do you have a question about the EH611X and is the answer not in the manual?
Questions and answers