Fastener Loading - Everwin SN40 Series Operation And Maintenance Manual

LOADING THE TOOL:

FASTENER LOADING

EYE PROTECTION which conforms to ANSI/ CE specifications and provides
protection against flying particles both from the FRONT and SIDE should
ALWAYS be worn by the operator and others in the work area when
connecting to air supply, loading, operating or servicing this tool. Eye
protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn.
Eye protection equipment must conform to the requirements of the ANSI
Z87.1 and 89/686/EEC, and provide both frontal and side protection. NOTE:
Non-side shielded spectacles and face shields alone do not provide adequate
protection.
TO PREVENT ACCIDENTAL INJURIES:
Never place a hand or any other part of the body in nail discharge area of
l
tool while the air supply is connected.
l Never point the tool at anyone else.
Never engage in horseplay.
l
l Never pull the trigger unless nose is directed at the work.
l Always handle the tool with care.
l Do not pull the trigger or depress the trip mechanism while loading the
tool.
Move pusher backward:
Loading Fasteners:
Release Pusher:
Pull pusher to rear until latched.
Cover will open. Pusher front will
drop into notch on the top of
magazine assembly.
Drop staple stick over magazine and
slide forward. Repeat until magazine
is loaded, allow enough space for
pusher to disengage the magazine
and cover to close. Approximately
1/2" (13 mm).
Pull and turn the knob in the
clockwise direction to release pusher.
10