Annual Maintenance - Weber Summit E-470 Owner's Manual

ANNUAL MAINTENANCE

Inspection and Cleaning of the Spider/Insect Screens
To inspect the spider/insect screens, remove the control panel . If there is dust or dirt on
the screens, remove the burners to clean the screens .
Brush the spider/insect screens lightly with a soft bristle brush (i .e ., an old toothbrush) .
m CAUTION: Do not clean the spider/insect screens with hard
or sharp tools. Do not dislodge the spider/insect screens or
enlarge the screen openings.
Lightly tap the burner to get debris and dirt out of the burner tube . Once the spider/
insect screens and burners are clean, replace the burner .
If a spider/insect screen becomes damaged or cannot be cleaned, please contact the
Customer Service Representative in your area using the contact information on our web
site . Log onto www .weber .com .
Burner Flame Pattern
The Weber gas grill burners have been factory set for the correct air and gas mixture .
®
The correct flame pattern is shown in illustration and described below:
A) Burner tube (1)
B) Tips occasionally flicker yellow (2)
C) Light blue (3)
D) Dark blue (4)
If the flames do not appear to be uniform throughout the burner tube, follow the burner
cleaning procedures .
◆
m ATTENTION: This product has been safety tested and is only certified for use in a specific country. Refer to country designation
located on outer carton.
These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products LLC, Customer Service
Department for genuine Weber-Stephen Products LLC replacement part(s) information.
m WARNING: Do not attempt to make any repair to gas carrying, gas burning, igniter components or structural components without
contacting Weber-Stephen Products LLC, Customer Service Department. Your actions, if you fail to follow this Product Warning,
may cause a fire, an explosion, or structural failure resulting in serious personal injury or death as well as damage to property.
36
MAINTENANCE
1
2
3
4