homechoice Sandhurst Instruction Manual page 5

Operating instructions
Warning: Never cover the heater or obstruct the vents at the base of the appliance, as
this may cause overheating and the risk of fire.
1 Dimming control - turn right to increase the brightness of the flame effect or turn left to
decrease the brightness of the flame effect.
2 Lamp switch (On/Off) - Switches the flame effect on or off.
Note: The flame effect can be operated with or without heat. To use the flame effect
without heat, only use the On/Off switch.
3 Switch (I) – Switches the 900 watt heat output on or off.
4 Switch (II) - Switches the 1800 watt output on or off when used with switch (I).
Note: If switch (I) is off and switch (II) is on the heat setting will be 900W.
5 Fan switch (On/Off) – Switches the fan on or off.
6 Temperature control knob - Turn to the right to increase heat output or turn to the left
to reduce heat output.
 Insert the plug into an appropriate power outlet.
 Open the control panel cover.
 Select the desired function.
– Flame effect On/Off (2)
– Fan (with or without heating) (5)
– Low heat 900W (3+5 or 4+5)
– Full heat 1800W (3+4+5)
– Heat and flame effect (1+2+3+4+5+6)
 The fan switch must be set to the On position to start the heating process. In the Off
position, the appliance will not start heating the room.
 Increase or decrease the flame effect by rotating the flame adjustment switch (1).
 Turn the Temperature control knob (6) clockwise or anti-clockwise to achieve the desired
room temperature.
Close the control panel cover after selecting the desired settings on the appliance.
■
133728R Sandhurst Fireplace Heater.indd 5
1 2 3 4 5 6
5
2014/12/05 3:46 PM