Table of Contents
Advertisement
C O N D I T I O N
New-Out of package.
DC power is present.
The Test button has been
pressed. The test sequence
lasts for approx 10 seconds.
Originating Smoke Alarm.
Originating CO alarm
Nuisance alarm
Smoke alarm when cause
of alarm is known and poses
no threat
CO alarm when cause of alarm
is known and poses no threat
Previous alarm condition at
unidentified source
Alarm needing reset due
to abnormal operation/
previous alarms
Low Battery
Product-End-of-Service-Life
Notification
Sensor Trouble
(Alarm Calibration) Warning
Quick Reference Guide Model AMIC3511S
ALARM AUDIBLE & VISUAL SIGNALS
HORN
Silent
Silent
approx. every
3 Beeps, 6
second pause,
4 beeps.
3 Beeps,
2 second
sync with the
pause, repeat
4 Beeps, 5
second pause,
approx. every
repeat
Horn sounds
when no hazard
sync with the
present
3 Beeps,
2 second
sync with the
pause, repeat
4 Beeps, 5
second pause,
repeat
Silent (alarmed
previously)
Silent (alarmed
previously)
1 Chirp approx.
every 60
seconds
2 Chirps ap-
prox. every 60
seconds
3 Chirps ap-
prox. every 60
approx. every
seconds
Silent
approx. every
SMK RED
CO RED
LED
LED
Off
Off
Blinks On
Off
2 minutes.
Blinks On in
Blinks On
sync with 3
in sync with
beeps.
4 beeps.
Blinks On in
Off
3 beeps
Blinks on
Blinks On in
sync with the
2 minutes
4 beeps
Blinks On in
Blinks On in
sync with the
3 beeps
4 beeps
Blinks On in
Off
3 beeps
Blinks on
Blinks On in
approx. every
sync with the
2 minutes
4 beeps
Blinks on
Off
approx. every
2 minutes
Blinks on
Off
approx. every
2 minutes
1 Blink ap-
Off
prox. every 2
minutes
1 Blink ap-
Off
prox. every 2
minutes
Blinks on
Off
2 minutes
3 Blinks
Off
2 minutes
Page 13
RECOMMENDATION
To activate the alarm remove the pull tab.
The alarm will sound one long beep to confirm
it is powered up.
Alarm is operating properly.
None
If hazard is identified, please take all precau-
tions if an alarm sounds by calling Emergency
Service and getting out of the home.
If hazard is identified, please take all precau-
tions if an alarm sounds by calling Emergency
Service and getting out of the home.
If there is no hazard present, verify the alarm
is mounted in the correct location (see user's
manual). Reset alarm as instructed below.
The smoke alarm Silence Feature can be
activated by pressing and releasing the Silence
button while in alarm condition. Silence mode
will last for approximately 8 - 12 minutes [With
the red smoke LED blinking on approx every
10 seconds].
The CO alarm Silence Feature can be
activated by pressing and releasing the Silence
button while in alarm condition. The alarm will
remain silent for approx 5 minutes [with the red
CO LED blinking on approx every 10 seconds],
depending on the level of CO detected. If CO
levels drop below alarm levels, the alarm will
remain silent and return to normal operation.
If CO levels remain constant or increase, this
indicates a potentially dangerous situation and
the horn will sound again. Ventilate area.
Quick Find
Alarm Origination - It may be dif-
®
ficult to determine which alarm has previously
sounded. The Quick Find
feature will allow
®
you to immediately locate the originating alarm
(once the alarm has stopped sounding). To
initiate Quick Find
press the Test/Silence
®
button on the alarm. After releasing the button
and following the test sequence, the originating
alarm will continue to sound for approximately
60 seconds.
To reset the alarm, hold the Test/Silence button
for 10-15 seconds. This will clear alarm origina-
tion. Reset after each alarm event.
Deactivate Alarm. See User's Manual "ALARM
DEACTIVATION" section. Replace alarm
immediately.
Deactivate Alarm. See User's Manual "ALARM
DEACTIVATION" section. Replace alarm
immediately.
Reset the alarm. See Reset Instructions below.
If this does not clear the problem, replace
alarm. Deactivate Alarm. See User's Manual
"ALARM DEACTIVATION" section. Replace
alarm immediately.
Clean Alarm. See MAINTENANCE instructions
on the following page. Reset the alarm. See
Reset Instructions below. If this does not clear
the problem, replace alarm. Deactivate Alarm.
See User's Manual "ALARM DEACTIVATION"
section. Replace alarm immediately.
Advertisement
Table of Contents
