Operating the appliance
en
Activating/deactivating: Touch and hold
the buttons Spin and Ready In for
approx. 3 seconds. The symbol E is
indicated in the display. If the button
signal is activated, an acoustic signal
sounds.
E lights up: The childproof lock is
■
activated.
E flashes: The childproof lock is
■
active and the programme selector
has been adjusted. To prevent the
E symbol from flashing, reset the
programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. If this is the case,
deactivate the childproof lock before the
programme starts and, if required, re-
activate after the programme starts.
Adding/removing laundry
After starting the programme, you can
add or remove laundry if necessary.
Touch the Start/Pause button. The
appliance checks whether reloading is
possible.
If the following appears on the display
panel:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
Start/Pause button. The programme
continues automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
38
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the Start/Pause button.
1.
Select another programme.
2.
And touch the Start/Pause button
3.
again. The new programme starts
from the beginning.
If drying is activated, you can
Note:
change the programme by programme
selector directly.
Interrupting or ending the
programme
For washing programmes at high
temperature:
Touch Start/Pause button.
1.
To cool down laundry: select Rinse.
2.
Touch Start/Pause button.
3.
For washing programmes at low
temperature:
Touch Start/Pause button.
1.
Select Spin.
2.
Touch Start/Pause button.
3.
For drying programmes:
Select Intensive Dry 5 or Gentle
1.
Dry ‰.
Touch Dry button, and set drying
2.
time to 15 minutes.
Touch Start/Pause button.
3.