Place Navigation Device Into Holder; Set Navigation Device To Desired Position; Memory Card - Nokia 500 User Manual

Hide thumbs Also See for 500:

Table of Contents

G e t s t a r t e d

the cup and the windscreen (2). Check that the suction cup is firmly

attached.

If you want to detach the mounting device from the windscreen,

carefully push the locking lever toward the top of the mounting device,

and pull the strap located on the edge of the suction cup.

Place navigation device into holder

To place the navigation device into the mobile holder, insert the catches

at the bottom of the holder into the recesses at the bottom of the device

(3).

Press the navigation device toward the back of the holder so that the

catches on the two arms of the holder click into the corresponding slots

at the sides of the device (4). Ensure that the screen is clearly visible for

the user.

If you want to release the navigation device from the mobile holder,

push the arms of the holder.

Do not adjust the mounting device while driving.

To set the navigation device to the desired vertical position, loosen the

two screws at the sides of the mounting device, turn the navigation

device to the desired position, and tighten the screws (5).

To set the navigation device to the desired horizontal position, loosen

the screw below the mounting device, turn the navigation device to the

desired position, and tighten the screw (6).

Ensure that the navigation device is firmly locked into place.

The device comes with a memory card and an adapter. You can only use

memory cards formatted with the FAT or FAT32 file system with this

device.

The device supports the SDHC (SD High-Capacity) standard that allows

for the use of memory cards of up to 16 gigabytes.

Table of Contents