Table of Contents
Advertisement
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide selector switch to the
REMOTE position (see Figure 47).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn burner on and off
with hand-held remote control unit.
IMPORTANT: Do not leave selector switch in
the REMOTE or ON position when pilot is not
lit. This will drain the battery.
Blower Control Knob (Optional Accessory)
OFF
Selector Switch in
Remote Position
Figure 47 - Setting Selector Switch, Gas
Control Knob and Variable Control Knob
for Remote Operation
ON/OFF SERIES MODEL HRC100
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 48).
TO LOCK press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK press both buttons together on
hand-held remote control until the light stops flash-
ing. The hand-held remote is now unlocked.
Indicator
Light
Figure 48 - On/Off Hand-Held Remote
Control Unit HRC100
121333-01A
oPeRATIoN
Variable Control Knob
ON
Gas Control Knob
in ON Position
Control
Button
www.ironhaus.com or www.desatech.com
Continued
THERMOSTAT SERIES MODEL
HRC200
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 49). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by
pressing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace
Note: Do not leave the hand-held remote in the
AUTO mode close to the fireplace. The radiant
heat from the fireplace will turn off the fireplace.
Ideally, place the hand-held remote in the center
of the room facing towards the fireplace.
Note: Do not hold the hand-held remote for
a long time. Body temperature will affect its
operation in the AUTO mode.
Digital Display Shows
Temperature and Settings
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or Off
Increases or
Decreases
Room
Temperature in
AUTO Mode
Figure 49 - Thermostat Hand-Held
Remote Control Unit HRC200
Turns
Hand-Held
Remote On
AUTO
ROOM
SET
or Off and
TEMP
TEMP
Allows You
TEMP
LOCK
to Choose
POWER
the Manual
Setting
MANU
AUTO
ºC/ºF
Selects
AUTO
Mode
°C/°F Mode Button
29
Advertisement
Table of Contents
