Table of Contents
Advertisement
Removing Inner Glass Door
If replacement of glass is necessary, entire
assembly, glass and frame, must be replaced.
If glass is broken, wear gloves and tape re-
maining fragments onto frame.
1. Lift up on latches to unlock. There are two
on top of firebox and two below firebox that
hold glass door in place (see Figure 43).
2. While holding glass door to prevent it from
falling and causing injury, remove five
screws from hinge located on left side of
door frame assembly (see Figure 43).
3. Remount new frame at hinge with five
new screws before closing door. This will
ensure seating of gasket.
4. Close glass door frame. Lock latches by
placing bar under tab on door and pushing
down and back on latch (see Figure 43).
5. Replace louvers by reversing procedure
under Removing Louver Panels, page 25.
Unlock
Lock
Latch
Screw
Hinge
Glass Frame
Assembly
Figure 43 - Removing/Replacing Glass
Cleaning Glass Door
See Cleaning and Maintenance on page 31.
INSTALLING LAVA ROCK AND
GLOWING EMBERS
It is very important to keep logs exactly as
installed. Do not modify logs. Only use log
set designed for this fireplace.
26
FIRePLACe INSTALLATIoN
Doors
www.ironhaus.com or www.desatech.com
Continued
WARNING: Logs are unitized
and not attached to the burner. Do
not handle log assembly by top logs.
Always pick up by the bottom.
Open louvers, unlock door latches and open
glass door. See Removing Inner Glass Door,
steps 1 and 2.
1. Pull ember material apart into pieces no
larger than a dime. Place these pieces
loosely and sparingly directly onto ex-
posed front section of burner (see Figure
44). This will create the glowing ember
appearance as flame touches ember
material. Do not block air slots by using
too much ember material in one area. Do
not block pilot ports with embers. It is not
necessary to use all of the ember material
provided.
2. Pour lava rock onto plenum but not onto
flat burner. It is not necessary to use all
of the lava rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner will cause
performance problems.
3. Close glass door, lock door latches, replace
screen and close louvers (see Removing
Inner Glass Door, steps 4 through 5).
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
Andiron
Ember Material
Figure 44 - Placing Ember Material on
Plenum
Burner
121333-01A
Advertisement
Table of Contents
