Table of Contents
Advertisement
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to a 9-volt alkaline
battery (not included). Place battery into
battery housing.
3. Replace battery cover onto remote control
unit.
Battery Cover
Remote Control Unit
Terminal
Wires
9-Volt Battery
Figure 40 - Installing Battery in Hand-
Held Remote Control Unit
REMOVING/REPLACING GLASS
DOORS
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place.
For replacement part informa-
tion see Replacement Parts,
page 37.
CAUTION: Wear gloves and
safety glasses while handling
or removing broken glass. Do
not remove if glass is hot. Keep
children and pets away from
glass.
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before
removing inner glass door or
louvers.
121333-01A
FIRePLACe INSTALLATIoN
Continued
Battery
Housing
www.ironhaus.com or www.desatech.com
Outer Door Installation
It is important that you remove glass doors
prior to installing your fireplace. To remove
doors, pull up and out to disengage pins.
Set doors aside until installation of fireplace
is complete. Reinstall doors by seating pin
on door into slot on enclosure frame (see
Figure 41).
Enclosure
Frame
Door
Figure 41 - Installing Glass Doors
Removing Louver Panels
Remove top and bottom louver panels by
simultaneously pulling both top end spring
latches towards center of appliance until
they are disengaged from locating holes
(see Figure 42). Repeat for bottom spring
latches and pull louvers outward. To install
or replace items removed, simply reverse
procedures above.
Louver
Panel
Figure 42 - Removing Louver Panel
Slot for
Pin
Pin
Spring
Latch
25
Advertisement
Table of Contents
