Carbest CD Series Owner's Manual page 17

4.1.2 DIN Rail Mounting
Push the rail - clip outside then mount it on a standard 35 mm DIN rail. Push
the rail - clip Inside to fasten the controller onto the DIN rail ( As below picures )
Note : The thickness of DIN rail should not more than 1 mm, suggest to choose
the 0,8 mm type.
Push-out
4.2 Battery and Controller Connecting
Please connect the controllers according this instruction !
Connect the wires leading to the battery
with correct polarity. To avoid any voltage
on the wires, first connect the controller,
then the battery. Mind the recommended
wire length ( min 30 cm to max approx.
100cm ) and the wire size:
10A : min 6mm
12A : min 6 mm
15A : min 8 mm
Warning : If the battery is connected with
reverse polarity, the load terminals will also
have the wrong polarity. Never connect
loads during this conditions !
Push-in
2
2
2
17