Silvercrest SKT 2000 B1 Operating Instructions Manual page 48

RP100157 Konvektor Timer LB1 Seite 46 Mittwoch, 11. Juni 2014 12:30 12
6.4 Fan function
The appliance is equipped with a fan to
distribute the air more quickly in the room.
To switch on the fan, press the fan switch 7.
A red indicator in the fan switch 7 will then
light up.
Note: The appliance can also be operated
without the fan being switched on. The heat
will then be concentrated more around the
convector and will not be distributed so
quickly in the room.
6.5 Setting the heating time
The appliance has a timer with which you
can set the required heating time.
1. Switch the timer on by setting the main
switch 14 to the Clocksymbol.
2. Turn the scale for the time 11 with the
control segments 12 until the current time
points to the hourly marking 13.
In this example the time is 09.15 am.
3. Select the times when the appliance is to
function by pulling
segments 12 to the outside from the
beginning to the end according to the
46
scale for the time 11.
In this example the heating time runs
from 01.00 pm to 07.15 pm.
4. To switch off the timer, move the main
switch 14 to "I " (continuous) or "0"
(appliance switched off).
6.6 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Set the main switch 14 to "0" to switch
off the power supply.
2. Make sure that the air can enter and
escape freely.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.
all control