Installing Fpims - Cabletron Systems FDDI User Manual

Chapter 3: Installation/Removal
3.2

INSTALLING FPIMS

Before installing the 7F06-02 module, attach the antistatic
wrist strap included with the SmartSwitch or SmartSwitch
module by following the instructions printed on the package.
The 7F06-02 module is shipped without FPIMs. To install an FPIM,
follow the procedure below:
1. Remove the module if it is installed in the 7C03 MMAC SmartSwitch
chassis by reversing the procedure in Section 3.3.
2. Remove the blank front cover over the FPIM slot.
3. Install the FPIM as shown in Figure 3-1. Ensure that the rear connector
is seated firmly before tightening the two mounting screws.
3-2 7F06-02 FDDI SmartSwitch Interface Module User's Guide
Figure 3-1 Installing an FPIM