Advertisement
F. TROUBLESHOOTING
1. A frame connection will not click into
place.
Be sure the connection point is free of
Ø
debris.
Gently lift the frame to allow it to find a
Ø
natural resting position. Lifting to relieve
pressure on the connections allows them to
fit more easily.
Firmly tap the connection point with your
Ø
palm.
If a button lock is not popping up, try flexing
Ø
the frame in various directions until it clicks
into place.
Do not use liquid-based lubricants on frame
Ø
connections, as this will attract more dust
and debris, making the connection less
functional in the future. Compressed air may
be used if nessesary to clean connection
points.
2. Wall panels will not meet in the
center.
Vinyl stretches to varying degrees
Ø
depending on ambient temperature. The
centers of the wall panels may not fully
overlap in all conditions, but it should be
possible to overlap the walls somewhat in
all conditions.
If the wall sections are not meeting,
Ø
re-stretch the vinyl starting from the
doorframe. Apply as much force as possible
and stretch the vinyl in small sections as
you work along the wall.
After several years, vinyl ages and can
Ø
harden and lose its elasticity. Eventually,
the vinyl walls of your shelter may need
to be replaced if they are cracking or not
stretching enough to complete the shelter.
3. Roof panel will not fit fully over the
frame
When securing the roof panel, start by
Ø
securing opposite corners of the roof panel
first. Be sure the roof collars are centered on
the key flanges.
As vinyl ages it can harden and lose its
Ø
elasticity. Eventually, the vinyl walls of your
shelter may need to be replaced if they
are cracking or not stretching enough to
complete the shelter.
4. Torn or worn-out vinyl
See the Vinyl Repair section (page 20) for
Ø
information on how to fix minor tears and
holes in your vinyl panels.
13
5. Shelter components will not fit in their
cases.
Moisture or dirt can add volume to the walls,
Ø
floor and roof of the shelter. Be sure all
surfaces are as clean as possible under the
conditions.
Push as much air as possible out of the
Ø
walls, roof, and floor as you are folding
them.
Pack rigid items, such as base bars, in the
Ø
bottom of cases, then fit softer items around
them.
Try changing the orientation of bulky
Ø
components, such as the end frame
assemblies.
Have several people put their weight on the
Ø
case lid and secure the latches.
Advertisement
