Electrolux EDV705H3WB User Manual page 8

8 www.electrolux.com
ANTI CREASE CYCLE
IN PROGRESS
The anti crease cycle is designed to help
prevent creases forming in the clothes
after normal drying cycle has ended.
The anti crease progress indicator will start
blinking with clean filter during the time
anti crease phase is running. The drum will
rotate for 5 seconds every minute and will go
for 1 hour Anti crease phase cannot be disabled.
NOTE:
Anti crease can be stopped at any time by
opening the door and removing the clothes.
END OF PROGRAM and
CLEAN FILTER REMINDER
When the drying program is completed,
the display will show text "End"
The Clean Filter LED turns on
and blinks at the end of each dry
cycle to serve as a reminder to
user to clean lint filter at the end
of each load.
START/PAUSE BUTTON
3
This button allows you to start or
pause the dryer to check the contents
or perhaps add more clothes.
NOTE: The dryer will not start
unless the door is closed.
(If door is not closed you
will hear 9 Beeps and "E40"
on display.)
SETTING DRYING MODE
This mode gives you the option of
selecting different drying levels.
Dry
Temp
Touch this touch pad to select the
drying mode. Corresponding light for
each mode is shown on display.
Drying mode can only be selected
during initial set up.
• Low
For small load
• Mid
For drying most fabrics.
• High
For drying delicates and synthetics at
lower heat for maximum care of
the fabrics. The Low Heat setting will
cause the heater to cycle on for shorter
time than the normal setting.
• Airing :
This setting does not heat.
ONLY circulate the air in the dryer to
shake out dust and refresh clothes
Program
Off
30 mins
60 mins
90 mins
Delicates
Synthetics
Refresh
Bedding
Energy Saver
Mixed Dry - Iron
Mixed Dry - Cupboard
Mixed Dry - Extra
Cottons Dry - Iron
Cottons Dry - Cupboard
Cottons Dry - Extra
Drying mode
Temp
Aring Low Mid
O O O
O O O
O O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
High
O
O
O
O
O
O
O
O
O
O
O
O
O
O