Baumatic BDWS45SS Instruction Manual page 37

Connecting to the mains water supply
IMPORTANT: Do not connect the appliance to your mains water
supply using an old or an existing water inlet hose. The inlet hose
supplied with the dishwasher is the ONLY one that should be used.
DO NOT CONNECT THE WATER INLET HOSE TO A HOT WATER
TAP.
IMPORTANT: The inlet hose is fitted with an aqua stop.
This MUST be fitted in the upright position, as shown in
the above diagram.
Connecting to the water outlet
o Secure the drain hose as outlined above (A or B) so that it
cannot move whilst the dishwasher is in use.
o Place the end of the drain hose in your drain pipe and push it a
short way down.
37
o The inlet hose will be located inside the
cabinet of the dishwasher.
o Connect the
threaded water tap that has a 3/4" thread
and to the inlet hose connector on the
appliance.
o Fully tighten the inlet hose to the water
tap and the dishwasher.
water inlet hose to a