Table of Contents
Advertisement
6. Use a spatula made of wood or plastic or
equivalent to open the inner door. Hold the
outer door, and push the inner door against
the top edge of the door. Lift the inner door.
3
7. Clean the oven door with water and soap.
Clean inner side of the door. Dry the oven
door carefully.
When the cleaning is completed, install the
glass panels and the oven door. To install the
oven door, do the above steps in the opposite
sequence.
4
5
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
There is no spark when you try to
activate the spark generator.
There is no spark when you try to
activate the spark generator.
There is no spark when you try to
activate the spark generator.
www.zanussi.com
2 2
4
6
5
The hob is not connected to an
electrical supply or it is connec-
ted incorrectly.
The fuse is blown.
Burner cap and crown are placed
incorrectly.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Possible cause
Remedy
Check if the hob is correctly con-
nected to the electrical supply.
Refer to the connection diagram.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Place the burner cap and crown
correctly.
19
Advertisement
Table of Contents
