Rinse Aid Indicator ( ); End Of Programme; Water Cut-Off Warning; Overflowing Warning - Beko DIS15011 User Manual

Operating the product

Rinse Aid indicator ( )

Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.

End of programme

C
When the programme you have
selected comes to an end, an
audible warning signal will warn
you to turn off your machine.
This audible signal will warn you
with certain intervals before it
turns off.
End of Programme indicator will light up
when the washing programme is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your
machine.
3. Close the tap.
4. Unplug the machine from the socket.
C
For energy saving, the machine
is automatically turned off
following the completion of the
programme or if the programme
is not started.
C
Leave your dishes in the
machine for about 15 minutes
to allow them cool down after
they are washed. Your dishes
will dry in a shorter time if you
leave the door of your machine
ajar during this period. This
process will increase the drying
effectiveness of your machine.
/41 EN
28

Water cut-off warning

If mains water is cut or water inlet tap is
turned off the machine cannot take water
in and P2 icon will flash on the programme
indicator. As long as the problem continues,
washing programme is paused and the
water inlet is checked regularly by the
machine; when the water is restored P2
icon will disappear after a while and the
washing programme resumes.

Overflowing warning

If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and P1
icon will flash on the Programme indicator.
As long as the overflowing continues
safety algorithm will be active and try
to discharge the water. If overflowing
stops and safety is assured, P1 icon will
disappear. If P1 does not disappear, there
is a permanent fault. In this case the
authorised service should be contacted.
Dishwasher / User's Manual